Revision Number: A
Work in Progress Standard: 2010-03-23
WIP – Not available for purchase at this time.
This SAE Standard covers the mechanical and material requirements for inch-series steel bolts, screws, studs, sems, and U-bolts used in automotive and related industries in sizes to 1-1/2 in inclusive. The term “stud” as referred to herein applies to a cylindrical rod of moderate length threaded on either one or both ends or throughout its entire length. It does not apply to headed, collared, or similar products which are more closely characterized by requirements shown herein for bolts. The mechanical properties included in Table 1 were compiled at an ambient temperature of approximately 20 °C (68 °F). These properties are valid within a temperature range which depends upon the material grade used and thermal and mechanical processing. Other properties such as fatigue behavior, corrosion resistance, impact properties, etc., are beyond the scope of this document and responsibility for ensuring the acceptability of the product for applications where conditions warrant consideration of these other properties must be borne by the end user.
Entre em contato e solicite seu orçamento
PTI / Hecker JF
Rua Peixoto Gomide, 209
01409-901 Sao Paulo, SP – BRAZIL
Fax :(11) 3159-2450
Authorized Subscription Agency – Booksellers – Information Consultant
Tem alguma questão adicional? – Sinta-se livre em contactar-nos.
We being an International Company, we can search all kinds of publications, print or electronic, from any part of the world. Our experience takes us back to 1971.